Shop Now, Pay Later with Affirm. Learn More

Synthesis Technology
E580 Resampling Mini-Delay - 14HP

Be the first to review this product

Item: N13-3586

$289.00
E580 Resampling Mini-Delay - 14HP

Synthesis Technology E580 Resampling Mini-Delay

The E580 from Synthesis Technology is a resampling delay module that recreates the sounds of BBD, digital, and tape delays. The module features four parameters, all under voltage control. In BBD mode, the E580 demonstrates exemplary pitch modulation with variable bandwidth—all without using so much as one BBD IC! In tape mode, the E580 features tape saturation and non-linear distortion modeled from vintage tape units. 

The module features two audio outputs, one a straight delay and the other a variable tapped delay. For the latter, the tap position consists of a percentage of the master delay time. This means that both extremely short and long delays are easily achievable under the right settings. Additionally, the module features jumper-selectable feedback sourced from either the tap position or the primary delay, allowing for the easy generation of rhythmic delays or pre-delays. 

E580 Resampling Mini-Delay Features

  • Wet/Dry: controls the mixture of the original input (dry) and the delayed signal (wet). Not that 100% dry is fully counterclock wise and 100% wet is fully clockwise. In general, the best sounds are in the 40-80% wet range.
  • Feedback: this sets the amount of delayed signal fed back into the input based on the option jumper. Note that this is a bi-polar control knob with zero feedback in the center position (12 noon).
  • Tap Offset: this sets the percentages of the Tap Out in relation to the Delay Time. For example, if the Delay Time is set to 100ms, the Tap sets from 0 to 100ms. The time resolution is very fine (over 7,000 independent positions) to allow very smooth modulation of the tap position.
  • Delay time: this sets the delay time for the Delay Out. Note that since Tap Out is a percentage of Delay, if you change Delay Time, you also change Tap Out delay time. But, the percentage of Tap to Delay is constant.
  • The 4 CV inputs do not have corresponding CV attenuators, and CV is added to the corresponding panel control.

Questions on E580 Resampling Mini-Delay - 14HP

No questions asked yet

Ask Your Own Question






 

  • +12V @ 105mA ; -12V @ 20mA
  • 14 HP
  • Max Delay Time:  780ms (0.78 seconds)
  • DSP engine: 16-bit, 39kHz sample rate.

Customer Reviews

Write Your Own Review

You're reviewing: E580 Resampling Mini-Delay - 14HP

How do you rate this product? *

  1 star 2 stars 3 stars 4 stars 5 stars
Rating