Shop Now, Pay Later with Affirm. Learn More

Synthesis Technology
E102 Quad Temporal Shifter - 14HP

Be the first to review this product

Item: N13-3580

$299.00
E102 Quad Temporal Shifter - 14HP

Synthesis Technology E102 Quad Temporal Shifter

The E102 from Synthesis Technology is a four-tap delay specifically designed for control voltages. The module includes an onboard noise generator, itself containing eight types of noise. The digital noise is sampled when nothing is patched into the CV input. When a CV signal is patched in, the module samples the input signal in tandem with each clock pulse, with each consecutive clock shifting the sampled voltage to the next output (Out 1 > Out 2 > Out 3). Each sample is stored internally as a 14-bit value.

E102 Quad Temporal Shifter Features

  • Control knobs for Rate, Delay, and Noise. Rate sets the internal sample/shift clock rate from ~0.5Hz to 925Hz. Delay sets the number of internal delay states based on the Delay switch positon. Noise selects 1 of 8 different types of noise spectra. Karplus-Strong 'pings' to pink noise!
  • Quantization Switch: if OFF will sample the input to the output. If ON adds whole-step quantization each sample clock. FLOW will ignore the sample clock and not do any shifting. The INPUT is quantized and copied to all 4 OUTs. This is the "stand-alone' quantizer mode. 1 whole step = 0.083V
  • The DELAY switch sets the 3 DELAY ranges between the states (not the total) as follows: Short: 1-8 (a "1" means 1 clock between stages or a "zero" delay); Medium: 1-32 clocks; Long: 1-511 clocks.
  • the INPUT jack is the input for the sampled CV. If no patch cord is inserted, the digital noise is sampled. the applied CV is sampled at the rising edge of the clock and appears as OUT1.
  • The WHITE OUT provides fixed spectra white noise output. Not effected by the NOISE pot or CV input.
  • the DIGITAL OUT provides the digital noise output.
  • the CLOCK OUT: a 0-6.5V square wave at the same rate as the internal clock.
  • The 3 Cv input control jacks do not have associated attenuators. The input range is -5V to +5V, but its important to note any applied CV is added to the matching panel control. Applied control CVs should be externally attenuated before patched into the E102.
  • The CLOCK IN takes any external LFO/VCO can over-ride the internal clock. For prest results, use a pulse/square wave or a sine. The external clock must be at least 3V pk-pk. The upper frequency limit is 3kHz. Exceeding 3kHz may result in erratic behavior with loss of output voltage accuracy. Yes, it is possible to sample low-frequency audio, EGs or LFOs.
  • The outputs OUT1-OUT4 contain the 4 CV outputs of the sampled INPUT. Each output can be thought as a 'tap' in a delay line, that can vary from a length of 4 (1-stage delay, the minimum setting) to 1533 (3x511).

Questions on E102 Quad Temporal Shifter - 14HP

No questions asked yet

Ask Your Own Question






 

  • +12V @ 50 mA; -12V @ 20mA
  • 14 HP

Customer Reviews

Write Your Own Review

You're reviewing: E102 Quad Temporal Shifter - 14HP

How do you rate this product? *

  1 star 2 stars 3 stars 4 stars 5 stars
Rating