NOTE: The 1U row in this case is only compatible with Intellijel 1U modules. Pulp Logic, Synthrotek and Vermona 1U modules are not compatible with this case.
Intellijel 4U cases are made of high quality extruded aluminum to be light and strong. They have a eurorack 3U row on the bottom and a 1U row for utility modules on the top. Modules are mounted to a threaded insert that uses M3 screws, so yo don't have to deal with sliding nuts. The top, bottom and back of the case have slots for M3 nuts or hex head bolts, so you can use the rows to attach things to the case, the rubber feet that the module stands on go in these slots so you can put them where you like. The inside of the case also has a set of rails that the power supply can be slid around on, so you never have to worry about a power cable being too short and not reaching your power supply.
This 84HP version of the 4U case comes with a TPS30W MAX power distribution board and an 40W Meanwell brick to power it. There are connectors to put 20 modules in the case and 1.5 Amps of power on both the +12V and -12V rails as well as 1 Amp on the +5V rail. This power supply is designed to be robust and low noise. A 2.1mm jack and power switch are on the left of the case for connecting the power and turning it off and on.
4U 84HP Powered Case Features
Single row Eurorack module space (3U) with additional 1U row along the top for mounting all sorts of essential utility modules
Super strong extruded aluminum design
Highly resilient surface finish that has been anodized and sandblasted
Threaded inserts allow for modules to be mounted with standard M3 screws, no sliding nuts!
Pairs of slots run along the three sides of the case. Each slot is sized to allow for M3 nuts or M3 Hex Head bolts to slide in the space. Perfect for attaching all sorts of interesting accessories and linking together multiple cases (both coming soon!)
A pair of custom extruded rubber “feet” come fitted on the bottom slots of the case. This rubber can be slid out when you remove an end cheek and then positioned on the front side of the case so that you can stand the cases vertically.
Power supply is mounted to a pair of inside bottom rails and can be re-positioned by loosening the fastening nuts and sliding the whole assembly left or right
Options to mount power entry and switch on the side cheek or in a 1U panel (optional extra cheeks without switch/jack holes are available)