The DUAL LFO module houses two individual low frequency oscillators (LFOs) used mainly for modulation purposes. Each LFO section offers three selectable waveforms, CV-input with attenuator and a rate ranging from 10 seconds to approximately 100 Hz. By applying positive or negative voltage, this range can be widened with a factor up to 30, resulting in extreme slow or fast modulation rates.
Both LFOs offer individual inputs to reset the waveform, making it possible to synchronize to a sequencer with appropriate rate settings and separate reset-impulses.
LFO 1 offers triangle, saw tooth down and square waveforms, LFO 2 offers triangle, saw tooth up and sample & Hold. Output voltages are +/- 5 volts at maximum.
When not patched, the two CV-inputs are internally cross-wired, meaning that LFO 1 controls the speed of LFO 2 and vice versa with both attenuators being active to set modulation intensity.
The module has a width of 40 mm (8 TE).
- Two voltage-controlled LFOs
- Interactive modulations
- Rate from 10 s to 100 Hz
- Saw tooth, square, triangle and sample & hold waveforms
- Separate reset-inputs
Questions on Dual LFO - 8HP
No questions asked yet
Ask Your Own Question
- Eurorack Module
- Width: 8HP
- Depth: 21mm
- Current Draw: 30mA @ +/-12V