Doepfer
A-160-2 Clock/Trigger Divider II - 4HP

Be the first to review this product

Item: N13-4912

Availability: In stock

$125.00
Free Domestic Delivery
World Wide Shipping
A-160-2 Clock/Trigger Divider II - 4HP

 

Module A-160-2 is an enhanced version of the standard clock divider A-160. The module is a frequency divider for clock/trigger/gate signals, designed to be a source of lower frequencies, particularly for rhythm uses. The Clock input will take any digital signal from, eg., an LFO, MIDI sync, or the gate from a MIDI-CV interface. At the outputs, you have access to three sets of seven different sub-divided clock signals, from half the clock frequency down to 1/128. The low/high levels of the output signals are 0V and about +10V.The A-160-2 also has a reset input. Whenever a reset signal is sensed, all outputs are set to certain levels which depend upon the selected mode.

Features

  • Three different sets of dividing factors, selected by a three-position switch at the front panel: power of two: 2, 4, 8, 16, 32, 64, 128; prime numbers: 2, 3, 5, 7, 11, 13, 17; integer: 2, 3, 4, 5, 6, 7, 8
  • Two output modes, selected by a two-position switch at the front panel: Gate mode: outputs act like the outputs of typical binary dividers; Trigger mode: in this mode the outputs are AND-wired with the clock signal (i.e. the clock pulsewidth affects the pulsewidth of the outputs)
  • Clock edge type selected by a jumper on the pc board: positive: the rising edge of the clock signal triggers the state change of the outputs; negative: the falling edge of the clock signal triggers the state change of the outputs
  • Reset behaviour by two jumpers on the pc board: level triggered: the level at the Reset input triggers the Reset; edge triggered: the edge of the signal at the Reset input triggers the Reset; positive: a high level (> 2.5V) or the rising edge at the Reset input triggers the Reset; negative: a low level (< 1 V) or the falling edge at the Reset input triggers the Reset
  • Output polarity selected by a jumper on the pc board: positive: non-inverted outputs; negative: all seven outputs are inverted

Questions on A-160-2 Clock/Trigger Divider II - 4HP

No questions asked yet

Ask Your Own Question






 

  • Eurorack Module
  • Width: 4HP
  • Depth: 35mm
  • Current Draw: 50mA @ +/-12V

Customer Reviews

Write Your Own Review

You're reviewing: A-160-2 Clock/Trigger Divider II - 4HP

How do you rate this product? *

  1 star 2 stars 3 stars 4 stars 5 stars
Rating