The Blue Lantern CMOS Master Divider has 4 musical division sections: divide by /2, /4, /8, /16. Then each section has a phased output where you can delay a trigger event for example.
This circuit is designed around the falling edge of the clock source (wave) input.
The module also features a powered multiple for repeating a signal. The multiple does not have any output resistor, so what you patch in is going to output an exact copy (important for pitch processing).
You use the module to breakdown a clock source, for example an LFO or VCO, into subdivisions for triggering events. All of the divided outputs are simultaneous, so you can patch to drum modules, high hats, sequencers, etc., at the same time.
The module will accept just about any wave: Saw, Sine, Triangle, Square, Ramp. Each one will influence the processing a little different as far as time is concerned. You can also use the outputs at audio rate as a subharmonic generator.
- Master Clock Divider Circuit
- 4 Main Division Outputs
- 4 Musical Division Sections
- 4 Phased Outputs per Section
- Powered Multiple
- Clock In/Thru
Questions on CMOS Master Clock Divider - 11HP
No questions asked yet
Ask Your Own Question
- Eurorack Module
- 11HP Width
- 32mm Depth