BASTL Instruments
Solenoid Motor Interface for Eurorack - 5HP

Be the first to review this product

Item: N13-4055

Availability: In stock



Solenoid Motor Interface for Eurorack - 5HP


Quad Trigger to Solenoid Motor Driver

SOLENOID can drive 4 solenoid motors with voltage directly from the power supply. Motor driving circuitry and CV input circuitry are optically isolated without any ground connection. Requires external power supply for driving motors. Output pulse width a knob optimizes the trigger signals to be sufficient to deliver adequate signal for the solenoids. With shorter pulses, solenoids don`t move in their full range, or move with less power. This can also be used for adjusting the dynamics.


  • Four channel solenoid motor driver
  • CV circuitry and motor circuitry is optically isolated
  • External power supply for motors required
  • Motors are driven directly from power supply
  • Trigger input per channel
  • Output pulse width knob applies to all channels

Questions on Solenoid Motor Interface for Eurorack - 5HP

No questions asked yet

Ask Your Own Question


  • Eurorack Module
  • Width: 5 HP
  • Depth: 50 mm
  • PTC fuse and diode protected 16pin power connector
  • Requires +5V in Power Bus

Customer Reviews

Write Your Own Review

You're reviewing: Solenoid Motor Interface for Eurorack - 5HP

How do you rate this product? *

  1 star 2 stars 3 stars 4 stars 5 stars